Easy to learn the basics and can do very complex things as you become more proficient. I have been using for two years now (Pro). I wouldn’t bother with AutoCAD unless I were using CNC, in which case you need the CAD. I use this program for everything including design, presentation, and cutlists. I used it for the first three years, then shelled out the cash for pro. Ninety nine percent of the drawing program is in the free version. All the pro version gives you is a presentation program (Layout) that as noted can beĭone with other outside programs. I would also download the free cutlist program and if you need higher resolution drawings you can also download the free Kerkythea program into SketchUp for photorealistic renderings.įor what you describe SketchUp can do easily in the free version. Your average customer will be thrilled with a well designed SketchUp drawing. I usually draw the picture then turn it to a jpeg and email it to the customer. I use SketchUp all the time for presentations. All I wanted to do is a layout of stud walls with the electric and plumbing showing, and it looks like I would have to spend $500.00 for SketchUp Pro (not doing that). However, it all still needs to be redrawn in AutoCAD to actually build the house faster and better because SketchUp is not supported by Google in ways that I feel are required. One person throws together fast 3D models of complex building and houses, does animations, etc. I work with people using this program all the time. If you want to complete serious submittal drawings it is not the one you want to use, but if you intend to use it for presentation/conceptual/preliminary design sketches it's great. It’s very easy to learn, actually no learning needed at all, and very intuitive. It has tons of glitches and creates exceptionally heavy (mb) files that are hard to email due to excessive size. If you try you can achieve more or less precise drawings in it. It’s a simple program, and does decent conceptual drafting. If anyone has any to share that would be appreciated. Then right click on the new door thumbnail and click on Replace selected.I would like to hear pros and cons about SketchUp. In fact you can select all the instances of the door component in the model by right clicking on its thumbnail in the In Model Components window. If you do this properly, you can select the doors of a given size in the model and the select the replacement door in the Components window and use Replace Selected. Partial overlay, place the origin in the corner where the left side and bottom rabbets meet. Put the origin on the back of the door instead of the front so that it goes in as an overlay door. If the doors are full overlay, set the origin up and to the right from the bottom corner by the amount of the overlay. Personally I wouldn’t leave the gap and would plane a little off the doors to suit. If you are going to draw the inset doors so there is a gap between the door and face frame, locate the origin over to the left and down by the width of the gap. For example, inset doors could have their insertion point at the lower, front left corner so that you can drop the door into place using the lower left corner on the face frame as the destination. Make sure all door components have the same relative insertion point (component origin) to make swapping them easier. I wanted to clarify a point I made earlier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |